Such posts should, however, be reported to an Administrator for review. In addition, no claim is made that posts made here will be free from profanity, obscenity, rude, hurtful, libelous or insulting opinions of the poster. As such, each reader should not rely on any information available here as accurate and should independently verify such accuracy. No claim is made that any information is accurate. All posts and other information available at Signs 101 should be viewed as the opinion only of the poster. Remove any previously installed attempts (via 'Add/Remove Printers'), and then try this I also was able to get the Mac version working using this method. For some jobs, I print and print&cut DIRECTLY from CorelDRAW X3. If you do it the other way, the computer the printer, it won't install successfully (at least it did not for me, 4 or 5 times!) This means, have the cable plugged into the printer and then plug the other end INTO THE COMPUTER when instructed to do so. The KEY, I found, was following the instructions, in the DRIVER manual, TO THE LETTER! BTW, my version on the CD I received was 1.30 get this one working first, then get the most recent Where it says on page 6, item 3 '.an connect the printer to the computer.' THIS is the KEY! Roland Versacamm Sp 300 Drivers For Mac 2017 The tech who originally set mine up couldn't get it ether, so a few months ago, I decided to tackle this, once and for all.

The WIN driver allows the SP-300 to be used as any other printer would be, from the 'print' dialog.

I ran into the same issue when trying to properly install the WINDOWS driver, as you are doing. I tried this and it still says the same thing! I'm itching to try this printer out but I can't install the dang driver! Has anyone had this problem before or know how to go about fixing it? I would be sooo greatful!! Please close all applications, restart windows and try the install again.' Just got a slightly used Roland SP-300 and installed the printer driver, thought I may have installed it wrong so I uninstalled it then actually followed the instructions on the Windows Driver Guide that came with the printer and as it's re-installing the driver I get a prompt, 'The Roland SP-300 Printer Driver cannot be added because the driver module is in use. Bottom line, I think we got ya covered! There are a few new things you have to learn about preparing the art for contour cutting, and about loading the vinyl onto the printer. ROLAND SP300V DRIVERS FOR MAC - Image not available Photos not available for this variation Stock photo. And I'll keep emailing Roland, of course. Re: Roland Versa Camm SP-300V Drivers for Windows 7? I finally connected the Versa Camm to a portable PC with Vista, gut I gess I'll try the emulation solution later. Roland Versa Camm Sp 300 Service Manual.Roland Versacamm Sp 300 Drivers For Mac 2017.

Roland versaworks for mac